top of page

TAE SHIELD SYSTEM ASSEMBLE
Initial Verification
_mov_01_00_16_00_Quadro002.png)
Examine the security seal on the box.
Remove the seal and check the components of the shield:
1 shield with warranty seal, 1 connector, 1 elevator, 2 M8 screws, 2 M8 washers, 2 M8 nuts, 1 M5 screw, 1 spring.
Preparation

Make sure your weapon is unloaded.
Note 1: Throughout the handling of the weapon, keep your finger off the trigger and point the muzzle in a safe direction.

-
1 Shield with warranty seal
-
1 Connector
-
1 Elevator
-
2 M8 screws
-
2 M8 washers
-
2 M8 nuts
-
1 M5 screw
-
1 Spring
Product Guide:
Step 1
Connector Assembly
Step 1: Insertion of the Screw
Insert the M5 screw into the central hole of the connector.
Step 2: Installation of the Spring
Fit the spring onto the M5 screw from the top of the connector.
Step 3: Assembly of the Elevator
Make sure the elevator's 'lock tooth' is positioned close to the plate.
Screw the M5 screw until the assembly is secured.

bottom of page